Clean fast door is widely used in new energy automobile factory: four reasons to replace the flat door

September 19, 2024

In recent years, with the enhancement of global awareness of environmental protection and the rapid development of the new energy vehicle market, the construction of new energy vehicle plants is also increasing. In the construction of these plants, a key supporting facility is the door of the workshop. In terms of the types of doors, clean fast doors and open doors are the two main options. However, some new energy car plants have recently shown obvious differences in the choice of doors

It is understood that in the construction projects of a number of new energy automobile plants, the number of clean fast doors far exceeds the flat door, and even reaches more than 50. Why in these factories, the proportion of clean fast doors is so high, and the flat door has been replaced or less choice? I'll explain it to you in detail.

Customers pointed out that due to the special production environment and needs of the new energy automobile plant, the clean fast door has more advantages than the flat door in maintaining temperature and humidity, improving work efficiency, and aesthetic appearance, as follows.

1. Make the temperature and humidity of the workshop more stable: in the production process of new energy vehicles, it is necessary to strictly control the temperature and humidity of the workshop to ensure the quality and performance of the vehicle. Compared with the flat door, the fast door can effectively prevent the outside air and dust from entering the workshop and maintain a stable production environment by its fast opening and closing characteristics.

2. It can improve the on-site work efficiency: the production rhythm of new energy automobile plants is usually fast, and it is necessary to frequently enter and leave materials and vehicles. Compared with the flat door, the clean fast door has a variety of automatic induction methods in addition to fast opening, which can effectively improve production efficiency and reduce waiting time.

3. Smaller occupied space: because of the particularity of the open door, the door needs to reserve at least 1/2 the width of the door on both sides of the door, and the clean fast door only needs to reserve 500mm on the door head, 450mm on the motor side, 150mm on the motor side, occupying less space on the site.

4. The appearance is more beautiful: the appearance of the clean fast door is more beautiful and atmospheric, which can highlight the image of the factory. In the modern production environment of the new energy vehicle factory, the beautiful appearance design can increase the elegant image of the factory and meet the requirements of modern factories.

Author:

Mr. Carl

E-mail:

info@ymcleanroomdoor.com

Phone/WhatsApp:

+8613537711878