Automatic sliding door air shower room maintenance points Shanghai Sujing

1. Regularly use the instrument to measure various technical indicators of the equipment. If it does not meet the requirements of technical parameters, it should be dealt with in time.

Automatic sliding door air shower room maintenance points:

2. According to the actual use, regularly remove the filter material from the primary air filter.

Automatic sliding door air shower room maintenance points:

3. When it is found that the wind speed becomes small, first check whether the surface of the primary air filter is black. If it is black, it means that the pre-filter has more dust and the resistance is increased, that is, the non-woven in the primary air filter should be removed. The cloth is cleaned or replaced.

Automatic sliding door air shower room maintenance points:

4. When the non-woven fabric is exchanged or cleaned, the wind speed cannot be increased, indicating that the high-efficiency air filter has been clogged and the resistance is increased. The high-efficiency air filter should be replaced.

Automatic sliding door air shower room maintenance points:

5. When replacing the high-efficiency filter, the ball-splashing plate must be removed, the high-efficiency filter should be taken out, and the new high-efficiency air filter should be replaced according to the specifications of the original high-efficiency filter. The arrow mark on the high efficiency filter should be confirmed during installation and the arrow should point in the direction of the air flow. And ensure a good seal to prevent leakage.

Automatic sliding door air shower room maintenance points:

6. After the high-efficiency filter is replaced, it is necessary to confirm that the frame has no leakage phenomenon, and use the dust particle counter to detect, and then reach the technical index before normal operation.

Automatic sliding door air shower room maintenance points:

7. Regularly repair and repair the electrical circuit. If there is any fault, refer to the electrical schematic for maintenance.

Automatic sliding door air shower room maintenance points:

8. Regularly enclose the door so that the electronic lock is aligned with its keyhole to prevent the lock pin from being stuck.

Automatic sliding door air shower room maintenance points:

9. The temperature of the equipment should not exceed 50 °C, and open flame is strictly prohibited.